- Nominal Impedance [Zn], 2 ohms [per enclosure]
- Sensitivity [SPLo], dB @ 1W, 1m 95
- Power Handling Watts, Peak (RMS) 800 (400)
- Enclosure Top Surface Depth, in (cm) 11 9/16 (29.4)
- Enclosure Bottom Surface Depth, in (cm) 14 13/16 (37.6)
- Enclosure Height, in (cm) 16 (40.6)
- Enclosure Width, in (cm) 17 1/2 (44.5)
The DCVR Series vented enclosures combine KICKER’s award winning line of subwoofers with computer-modeled & human fine-tuned enclosures to offer a level of bass performance never before thought possible from a commercially available, ready-to-install subwoofer system. The DCVR Series enclosures are available w/a pair of pre-loaded 10 or 12 inch CompVR subwoofers. The VCVR Series enclosure is available w/a pre-loaded 12 or massive 15 inch CompVR. The location & orientation of your enclosure will affect the quality & quantity of the bass. Designed for use in SUV & sedan type vehicles, these enclosures offer you several mounting options. The vent opening in these enclosures can not be obstructed. At some frequencies most of the bass will come out of the vent. Therefore we recommend you leave at least four inches (10cm) of clear space around the vent.
If the enclosure is to be mounted all the way in the back of the vehicle, it works best to point the woofer toward the front of the vehicle. Conversely, if the enclosure is going to be mounted closer to the back seat, pointing the woofer toward the rear of the vehicle will give you the best results. These guidelines pertain to enclosures mounted in the vehicle as outlined in Figure 1. If it is more convenient to mount the enclosure along a side wall, put the enclosure on the left side of the vehicle as outlined in Figure 2. This orientation will make the vent point toward the rear of the vehicle & will produce the most low bass output. Remember to leave at least four inches (10cm) of room between the enclosure & the back of the vehicle.
After determining the best mounting position, carefully check the areas where the mounting brackets will be placed. Make sure the mounting screws will not puncture the gas tank, brake lines, wiring, or interfere w/any mechanical parts on the underside of the mounting surface. Turn the enclosure upside-down, pre-drill the holes using a 7/64” (2.5mm) bit & attach the four mounting brackets to the